Avaya 03-300430 User Manual

Page of 2574
Communication Manager Maintenance-Object Repair Procedures
1422 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
 
4-Character LED
The 4-character LED is used to display the circuit pack status related to the Ethernet interfaces. 
If automatic IP address assignment via DHCP is enabled, the top character displays the Switch 
ID and the next two characters display the Cabinet Number. The last character is used to 
display the link status of the two Ethernet interfaces.
Services Interface
The top RJ45 jack is the services interface. This is a 10/100 BaseT Ethernet interface.
Control Network Interface
The bottom RJ45 jack is the control network interface. This is a 10/100 BaseT Ethernet 
interface. This interface is active only when the IPSI I/O adapter is not plugged onto the 
Amphenol connector, located on the rear of the carrier.
PN’s Maintenance Board Interface
The PN’s Maintenance board interface is a header on the IPSI circuit pack with a slit on the 
faceplate of the IPSI for the ribbon cable to connect to the PN’s TN775D Maintenance board.
Error Log Entries and Test to Clear Values
System Technician-Demanded Tests:
Descriptions and Error Codes
There is no system technician demand test for this MO.
Table 510: LIC-ERR Error Log Entries
Error Type
Aux 
Data
Associated Test
Alarm 
Level
On/Off 
Board
Test to Clear Value
18 
The IPSI circuit pack 
is busied out by 
maintenance 
personnel. 
0
busyout 
ipserver-in
terface 
location
WRN
OFF
release 
ipserver-interface 
location