Avaya 03-300430 User Manual

For systems supporting circuit packs (S8700, S8500) 

 illustrates a UDS1 Interface 

circuit pack located in the PN. When the UDS1 board resides in a PN, there is additional PNC 
hardware connecting the packet buses of the IPSI PN and PN. Examples of such hardware are 
the Center Stage Switch and fiber-optic cables.

(blank)

ABRT

Internal system error.

1. Retry the command a 1-minute intervals up to 5 times.

1006

ABRT

There are no associated B channels in an ISDN in-service or maintenance 

service state.
For country protocol 1 interfaces (including the USA), either there are no 

B-channels administered in this signaling group, or all B-channels in this 

signaling group are either out-of-service or are in a “pending” state (PINS or 

PMTC, indicating that a B-channel maintenance message for that B-channel 

has been sent and not yet acknowledged). 
This is a NORMAL ABORT.

1. Administer or release an ISDN trunk or PRI endpoint before retrying the 

test. For an ISDN trunk, use status trunk grp#/mem# to verify the 

ISDN trunk state. For a PRI endpoint use status pri-endpoint 
extension. Then, retry this test when at least one B channel is in the 

in-service or maintenance states.

For systems not using country protocol 1 interfaces, there are no B-channels 

administered in this signaling group.

1019

ABRT

There is already a Remote Layer 3 Query in progress. This is a normal 
ABORT.

1. Wait two minutes, then follow the procedures for when this test passes.

 1 of 3

PKTINT

PACKET

BUS

UDS1

TN464C/D

TO FAR-END

(TN1655)

PROCESSOR

CIRCUIT

PACK CIRCUIT

PACK

PROCESSOR

(UN331)

INTERFACE