Avaya 03-300430 User Manual

4

FAIL

There is a problem with the Processor Interface Link. No DS1 ISDN Trunk 
(B-channel) or Wideband PRI Endpoint calls can be made until the problem 
is resolved.

1. Display the Communication-Interface Links Form via display 

communication-interface to determine which link is down (find the 

one that matches the DS1 Interface circuit pack on which this ISDN-PRI 
Signaling Link Port resides) and then refer to 

8

FAIL

There is a problem with the TN464C or higher suffix UDS1 Interface circuit 
pack or the MM710 DS1 Interface Media Module, or the ISDN-PRI 
Secondary Signaling Channel (D channel). No ISDN trunk or PRI endpoint 
calls can be made until the problem is resolved.

1. Consult the procedures for the UDS1 TN464C or higher suffix circuit 

pack (UDS1-BD), (DS1-BD), or the MM710 DS1 Interface Media Module 
(MG-DS1), and the ISDN-PRI Signaling Channel (ISDN-LNK).

PASS

The basic physical connectivity of the Signaling Group’s Secondary D channel 

is intact and functional. Try this test repeatedly to ensure the link is up and to 

uncover any transitory problems.

Any

NO 

BOARD

The test could not relate the internal ID to the port (no board). This could be 

due to incorrect translations, no board is inserted, an incorrect board is 

inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute add ds1 location 

to administer the circuit pack or media module interface if it is not already 

administered.
If the board was already administered correctly, check the error log to 

determine whether the board is hyperactive. If this is the case, the board is 

shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then enter busyout 

board location.

Enter reset board location.

Enter release location board.

Enter test board location long.

This should re-establish the linkage between the internal ID and the port.

 2 of 2