Avaya 03-300430 User Manual

The Conference Circuit test verifies that the NPE channel for the port being tested can correctly 
perform the conferencing function. The NPE is instructed to listen to several different tones and 
conference the tones together. The resulting signal is then measured by a tone detector port. If 
the level of the tone is within a certain range, the test passes.

Note:

: On the G700/G350, this test aborts with Error Code 1412.

Note:

The TN464C or higher suffix UDS1 circuit pack has one SCOTCH-NPE chip 
instead of several NPE chips.

 /

:

1412

ABRT

This test does not execute on a G700 Media Gateway.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

2020

ABRT

The test did not run due to an already existing error on the specific port or 
a more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit 

pack and attempt to diagnose the already existing error.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

The NPE of the tested port was found to be transmitting in error. This will 
cause noisy and unreliable connections. The ISDN-TRK is moved to 
out-of-service/near-end state.

1. Replace the circuit pack.

PASS

The port is able to communicate over the TDM Bus.

 2 of 2