Avaya 03-300430 User Manual

The DS1 ISDN Trunk depends on the health of the appropriate TN464C or later UDS1 Interface 
circuit pack, TN767 DS1 interface circuit pack, or MM710 DS1 Interface Media Module for 
proper operation. It also depends on the ISDN-PRI D channel (ISDN-LNK) trunk. This test 
checks the status of those critical elements.

Any

NO 

BOARD

The test could not relate the internal ID to the port (no board). This could be 

due to incorrect translations, no board is inserted, an incorrect board is 

inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute add ds1 

location command to administer the MM710 interface if it is not already 

administered.
If the board was already administered correctly, check the error log to 

determine whether the board is hyperactive. If this is the case, the board is 

shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then enter 

busyout board location.

Enter reset board location.

Enter release board location.

Enter test board location long.

This should re-establish the linkage between the internal ID and the port.

 2 of 2

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

0

ABRT

1018

ABRT

Maintenance is disabled on this trunk.

1. Enable maintenance by entering y in the Maintenance Tests field on 

the change trunk-group form.

1114

ABRT

The signaling link is in a transitional state.

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2