Avaya 03-300430 User Manual

Page of 2574
Communication Manager Maintenance-Object Repair Procedures
1544 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
 
SAKI Sanity Test (#53)
This test is destructive.
This test is only run as a part of a reset board procedure. For the Media Processor, use change 
ipserver-interface
 to disable the Media Processor IP interface before performing this 
reset board procedure. Use reset board location to reset other common circuit packs, 
and to also execute this test.
A reset of this circuit pack will take about 3½ minutes.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This 
could be due to incorrect translations, no board is inserted, an incorrect 
board is inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Administer the 
MedPro interface if it is not already administered.
2. If the board was already administered correctly, check the error log 
to determine whether the board is hyperactive. If so, the board was 
shut down. Reseating the board re-initializes it.
3. If the board was found to be inserted correctly, enter busyout 
board location.
4. Enter reset board location.
5. Enter release board location.
6. Enter test board location long.
This should re-establish the linkage between the internal ID and the port.
Table 565: Test #52 Control Channel Loop-Around Test  (continued)
Error
Code
Test
Result
Description / Recommendation
 2 of 2