Avaya 03-300430 User Manual

1000

ABRT

System resources required to run this test are not available. The port 
may be busy with a valid call.

1. Use display port location to determine the station extension 

of the port. Use status station to determine the service state of 

the port. If the port is in use, wait until the port is idle before testing.

2. If the port status is idle, then retry the command at 1-minute intervals 

up to 5 times.

1004

ABRT

The port was seized by a valid call during the test. The test has been 
aborted.

1. Use display port location to determine the station extension 

of the port. Use status station to determine the service state of 

the port. If the port is in use, wait until the port is idle before testing.

The battery feed circuitry is tested for proper battery voltage by testing 
the switchhook state. In response to the test message, the on-board 
firmware terminates the line and checks for switch-hook presence. The 
termination is then removed, and a check is made for no switch-hook 
presence. The MET set must be on-hook for the test to execute.

1. If the port status is idle, then retry the command at 1-minute intervals 

up to 5 times.

1018

ABRT

Test disabled by software patch.

2000

ABRT

This port may have been busied out.

1. Look in the Error Log for Error Type 18 (port busied out) for this port. 

If this error type is present, then release the port using release 
station extension and run the test again.

2. Make sure that the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test. This 
could be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 3