Avaya 03-300430 User Manual

2000

ABRT

Response to the test was not received within the allowable time period. 

This may be due to hyperactivity. Error Type 1538 in the error log indicates 

hyperactivity. The hyperactive Media Module is out of service and one or 

more of the following symptoms may be exhibited:

●

The MG-DS1 tests (such as Test #138 and Test #139) are aborting 
with Error Code 2000.

●

The tests run on the ports of this Media Module are returning a no 
board result.

●

A busyout or a release command has no affect on the test 

results.

●

A list config command shows that the Media Module and the 

ports are properly installed.

When hyperactivity occurs, the Media Module is isolated from the 
system, and all of the trunks for this Media Module are placed into the out 
of service state. The system will try to restore the Media Module within 15 
minutes. When no faults are detected for 15 minutes, the MM710 
interface Media Module is restored to normal operation. All of the trunks 
for the MM710 interface Media Module are then returned to the in service 
state. Hyperactivity is often caused by the associated facility. In such a 
case, faults (such as slips, misframes, or blue alarms) would be entered 
in the error log. In addition, many hardware errors would be logged 
against the associated trunk circuits. 

1. If the facility is OK and the error occurs again after 15 minutes, 

replace the Media Module.

 2 of 6