Avaya 03-300430 User Manual

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call.

1. Retry the command at 1-minute intervals up to 5 times.

2. Use status conference to determine if there is an active 

conference. If a call is active, the test cannot run until the conference 
call finishes.

1002

ABRT

The system could not allocate time slots for the test. The traffic load on the 
system may be very high, or time slots may be out-of-service due to 
TDM-Bus errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

repeat the test at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone detector for the test. The system is 
oversized for the number of tone detectors present or some tone detectors 
are out-of-service.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the test at 1-minute intervals up to 5 

times.

1004

ABRT

The resource has been seized by a user for a valid call. Use status 
conference to verify that there is an active conference call.

1. If there are no conference calls, retry the command at 1-minute 

intervals up to 5 times.

2000

ABRT

Response to the test was not received from the Tone Detector circuit pack 
within the allowable time period.

1. If this result occurs repeatedly, reset the circuit pack, if the other ports 

are idle. Reset the circuit pack by issuing busyout board 
location and reset board location, followed by release 
board location.

2. If this result occurs again, replace the circuit pack.

2012

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2