Avaya 03-300430 User Manual

6000

ABRT

System resources needed to complete the test could not be allocated for 
the digital section of the Modem Pool conversion resource. Ordinarily, this 
means the conversion resource or other hardware used during the test 
was in use.

1. Wait 1 minute and attempt the test again.

2. If the same error occurs, use status port to determine whether the 

Modem Pool conversion resource is in use.

3. If the conversion resource is in use, and it is absolutely necessary to 

test it, the call must be dropped by issuing busyout port 
location against the conversion resource. Run the test again.

4. If the same error occurs while the conversion resource is idle, busyout 

both Modem Pool conversion resources on the TN758 Pooled Modem 
circuit pack containing the conversion resource under test.

5. If the test continues to fail or abort, replace the Pooled Modem circuit 

pack and retest.

6001

ABRT

System resources needed to complete the test could not be allocated for 

the analog section of the Modem Pool conversion resource. Follow the test 

procedures for the previous Error Code.

None

FAIL

The test failed. This error is internal to the Pooled Modem circuit pack and 
does not involve external equipment or interfaces.

1. Busyout both of the TN758 Pooled Modem conversion resources on 

the circuit pack containing the failing conversion resource.

2. If the test continues to fail, replace the Pooled Modem circuit pack 

and retest.

ANY

FAIL

The NPE of the tested port was found to be transmitting in error. This 
condition will cause noisy and unreliable connections.

1. If the remaining ports are currently idle (amber LED is off), reset the 

circuit pack and repeat the test.

2. If the test fails again, replace the circuit pack.

PASS

The port is correctly using its allocated time slots. Investigate user-reported 

troubles on this port using other port tests and by examining station, trunk, 

or external wiring.

 3 of 3