Avaya 03-300430 User Manual
PKT-INT (Packet Interface)
Issue 1 June 2005
1819
Memory Checksum Test (#884)
This test involves sending a message to the Packet Interface module to run private
nondestructive memory checksum tests on the firmware text residing in Boot PROM and
FLASH memory on the IPSI circuit pack. If the test fails during background testing, the Packet
Interface module remains operational until an executed reset. Then, the initialization firmware
fails and puts the Packet Interface in an out-of-service state.
nondestructive memory checksum tests on the firmware text residing in Boot PROM and
FLASH memory on the IPSI circuit pack. If the test fails during background testing, the Packet
Interface module remains operational until an executed reset. Then, the initialization firmware
fails and puts the Packet Interface in an out-of-service state.
Table 669: Test #884 Memory Checksum Test
Error
Code
Code
Test
Result
Result
Description / Recommendation
1006
1137
1137
ABRT
Because the IPSI’s Packet Interface module is out of service, normal
maintenance tests do not run on the Packet Interface.
maintenance tests do not run on the Packet Interface.
1. Use reset packet-interface location to reset the Packet
Interface.
For further action, see the repair procedures in
on page 1836 for the Packet Interface Reset test (#889).
1334
ABRT
The Packet Interface command queue is full. This should be a temporary
condition caused by a high rate of commands being sent to a Packet
Interface. Continued operation with a full command queue causes a
system WARM restart that may escalate to more severe restart levels.
condition caused by a high rate of commands being sent to a Packet
Interface. Continued operation with a full command queue causes a
system WARM restart that may escalate to more severe restart levels.
1. Retry the command at 10-second intervals up to 5 times.
1335
ABRT
Internal IPSI error. The Packet Interface module is on the standby IPSI, so
this test is not allowed to execute.
this test is not allowed to execute.
1. Use set ipserver-interface location to make the standby
Packet Interface active.
2. Run the test.
2000
ABRT
Response to the test request was not received within the allowable time
period.
period.
1. Retry the command at 1-minute intervals up to 3 times.
2500
ABRT
Internal system error
1. Retry the command.
1 of 3