Avaya 03-300430 User Manual

NO 

BOARD

The IPSI circuit pack’s Packet Interface module is assigned, but is not 
detected as being physically present.

1. If the IPSI circuit pack is present, replace it.

2. If the IPSI circuit pack is not present, insert a TN2312AP IPSI circuit 

pack in the assigned slot, and run the test again.

1

FAIL

The Boot PROM memory checksum test failed. The circuit pack may still 
be operational.

1. This may be the result of old firmware not supporting new software 

operation. Verify the IPSI circuit pack’s firmware vintage and download 
the new firmware if appropriate.

2. The firmware image on the IPSI circuit pack may have been corrupted. 

Download the firmware image.

3. Retry the command.

4. The same Error Code occurs:

a. If this is a standard- or duplex-reliability system, replace the circuit 

pack at a time that would cause the least disruption of service. The 
circuit pack is still functional but should be replaced since it may not 
operate after a system reboot and it will enter a fatal fault state if it is 
reset for other reasons.

b. If the Packet Interface module is on the standby IPSI (

: and 

this is a high- or critical-reliability system), replace that circuit pack.

c. If the Packet Interface module is on the active IPSI (

: and 

this is a high- or critical-reliability system), use set 
ipserver-interface to perform a planned IPSI interchange.

 2 of 3