Avaya 03-300430 User Manual

●

Broadcast Link Loop Around

Each ISDN-BRI port has two associated broadcast signaling links, one for call control, and 
one for maintenance and management. Since these links have separate routing circuitry 
from the Level-2 Loop Around, this test forces a CRC error to verify the CRC hardware 
associated with the broadcast data path.

These tests are also run as part of the reset tests. If the Level-2 Loop-Around test fails as 
background tests, a fatal-error message is sent to the Packet Interface modules’s maintenance 
software, and the Packet Interface is put in the out-of-service state. Repair procedures 
associated with Abort Code 1137 (out of service) normally follow failures of the level-2 test.

1006

1137

ABRT

Packet Interface module is out of service, so normal maintenance tests do 
not run on the Packet Interface.

1. Use reset packet-interface location to reset the Packet 

Interface circuit.

For further action, see the procedures in 

on page 1836 for the Packet Interface Reset test (#889).

1334

ABRT

The Packet Interface modules’s command queue is full. This condition 
should be temporary, caused by a high rate of commands being sent to a 
Packet Interface. Continued operation with a full command queue causes 
a system WARM restart that may escalate to more severe restart levels.

1. Retry the command at 10-second intervals up to 5 times.

1335

ABRT

Internal IPSI error. The Packet Interface module is on the standby IPSI, so 
this test is not allowed to execute.

1. Use set ipserver-interface location to make the standby 

Packet Interface active.

2. Run the test.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error

1. Retry the command.

 1 of 3