Avaya 03-300430 User Manual

1

FAIL

Setting up peer links between the active and standby IPSI circuit pack’s 
Packet Interface modules failed. The standby IPSI circuit pack’s Packet 
Interface module did not respond to the peer link setup.

1. This may be the result of old firmware not supporting new software 

operation. Verify the IPSI circuit pack’s firmware vintage and download 
the new firmware if appropriate.

2. The firmware image on the IPSI circuit pack may have been corrupted. 

Download the firmware image.

3. Retry the command.

4. If the same Error Code occurs, use display alarms to display 

active alarms.

5. If errors related to the packet bus exist, see 

page 1790 and clear those problems first.

6. Retry the test command after a 1-minute delay.

7. If the test continues to fail, replace the standby IPSI circuit pack.

2

FAIL

Setting up peer links between the active and standby IPSI circuit pack’s 
Packet Interface modules failed. The active IPSI circuit pack’s Packet 
Interface module did not respond to the peer link setup.

1. This may be the result of old firmware not supporting new software 

operation. Verify the IPSI circuit pack’s firmware vintage and download 
the new firmware if appropriate.

2. The firmware image on the IPSI circuit pack may have been corrupted. 

Download the firmware image.

3. Retry the command.

4. If the same Error Code occurs, retry the test command after a one 

minute delay.

5. If the test continues to fail, replace the IPSI circuit pack.

PASS

The media server can communicate with the IPSI circuit pack’s Packet 
Interface module.

1. If problems are still reported on the Packet Interface, check for failures 

using the Private Loop-around test (#885) and Maintenance 
Loop-around test (#886).

 3 of 3