Avaya 03-300430 User Manual

Notes:

a. Error Type 0: run the short test sequence first. If every test passes, run the long test 

sequence. Refer to each test’s description and follow its procedures. Both PMS Printer and 
Journal Printer are administered to the same extension, and the printer is not connected. 
Refer to the 

 for resolution.

b. Error Type 18: the Journal Printer Link has been busied out and the link is torn down. Enter 

release journal wakeup-log | pms-log to restore the link.

c. Error Type 257: link Retry test (#215) fails. Physical link cannot be set up, usually because 

of hardware problems such as power off or cable disconnect. See 

d. Error Type 513: physical link cannot be set up, usually because of hardware problems such 

as power off or cable disconnect. The PMS Printer Link physical link is down due to the 
following causes: cable to the printer device is disconnected, the printer device is powered 
off, or the data extension where the printer device connects to has been busied out. Check 
the connectivity of wire and cable among wall jacket, data module, and the printer device. 
Enter status data extension and verify that the data extension of the printer device is 

in the in-service/idle state. If the data extension is not available, then see 

0 (

0

Any

Any

Any

18 (

0

WRN

OFF

257 (

)

Any

Link Retry test 

(#215)

MIN

1

 

WRN

1. Minor alarms may be downgraded to Warning alarms based on the value used in set options.

OFF

513 (

) Any

769 (