Avaya 03-300430 User Manual

2000

ABRT

Response to the test request was not received within the allowable 
time period.

1. Retry the command at 1-minute intervals up to 5 time.

2. If the test continues to ABORT with Error Code 2000, check for 

system powering problems with the A carrier. Look for and resolve 
every AC-POWER and CARR-POW alarm in a multicarrier cabinet 
system. Repeat the test.

3. If the test continues to ABORT with a 2000 Error Code, check for 

and resolve every MAINT (Maintenance circuit pack) error in a PN. 
Repeat the test.

2029
2319
2320
2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

2

FAIL

The system is in nominal power holdover, and the battery is so low that 
the system will disconnect power very shortly.

1. If power returns, then the port carriers in the PN should power-up 

again. Every circuit pack should be reinserted, and the system 
should continue to operate normally. There will probably be a 
minor alarm against battery and battery charger due to the fact that 
the batteries are recharging.

2. If power does not return, the system will shut down to prevent 

damage to the batteries. Restore power, and the system will 
reboot. No manual intervention is required.

3. Rerun the test. If the test still fails, then the PN’s MAINT 

(Maintenance) circuit pack could be reporting this condition 
incorrectly. Resolve every alarm on this MO, and rerun the test. 
There are failures that can occur on the PN’s Maintenance circuit 
pack that will not be detected by their respective maintenance, but 
which will cause many, if not every, environment tests to fail. If 
many environment tests are failing, the suspect circuit pack, 
depending on the system configuration, should be replaced and 
the test rerun.

 2 of 5