Avaya 03-300430 User Manual

One or more Network Processing Elements (NPEs) reside on each circuit pack with a TDM-bus 
interface. The NPE controls port connectivity and gain, and provides conferencing functions on 
a per-port basis. The Conference Circuit test verifies that the NPE channel for the port being 
tested can correctly perform the conferencing function. The NPE is instructed to listen to several 
different tones and conference the tones together. The resulting signal is then measured by a 
Tone Detector port. If the level of the tone is within a certain range, the test passes.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

The NPE of the tested port was found to be transmitting in error. This will 
cause noisy and unreliable connections.

1. Replace the circuit pack.

PASS

The port is correctly using its allocated time slots. User-reported troubles on 

this port should be investigated using other port tests and by examining the 

Error Log.

 2 of 2

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call and therefore unavailable for certain tests. Wait 
until the port is idle (amber LED is off) before retesting.

1. If the port is idle, retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a valid call during the test and the test has been 
aborted. Wait until the port is idle (amber LED is off) before retesting.

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2