Avaya 03-300430 User Manual

A series of dual-tone multifrequency (DTMF) tones are conferenced from the TDM bus into the 
port’s DTMF receiver and checked to see if the correct tones have been detected during the 
correct intervals. If every DTMF tone was detected correctly, the test passes. If any of the tones 
were not detected correctly, the test fails.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call and therefore unavailable for certain tests. Wait 
until the port is idle (amber LED is off) before retesting.

1. If the port is idle, retry the command at 1-minute intervals up to 5 times.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

Any

FAIL

DTMF tones were not detected. This type of failure may cause features 
using touch-tone input to the Speech Synthesis port to malfunction.

1. Verify that the Tone-Clock circuit is functioning correctly by checking 

the Error Log and using test tone-clock long.

2. If the test fails again, replace the Speech Synthesis circuit pack.

PASS

The port has detected every DTMF tone correctly. User-reported troubles 
should be investigated using other tests and by verifying other ports on this 
circuit pack are working correctly.