Avaya 03-300430 User Manual

2306

ABRT

None of the circuit packs in this switch node carrier are responding to the 
processor route messages sent by software.

1. Run test led switch-node for the switch node where this switch 

node carrier resides to verify whether the LEDs on any of the boards 
light.

2. If none of the LEDs light for the boards in this carrier, fix any problems 

associated with the connectivity of this carrier to the server.

a. Use list fiber-link to see the fiber connections to this carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.

c. Enter display errors, and follow the repair procedures for any 

EXP-INTF error entries associated with an IPSI connected PN.

d. Also, follow the repair procedures for any SNI-BD, SNC-BD, 

FIBER-LK, or SNI-PEER error entries.

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

FAIL

If this test fails, one or more administered circuit packs in this switch node 
carrier did not respond with a “board insertion” uplink message. Use list 
config carrier location to verify that administered SNI and SNC 

boards match the physically installed SNI and SNC boards. The command 
output shows NO BOARD for every board that is administered, but not 
inserted.

1. If every administered board is inserted, run this test again.

2. If administration does not match the physical configuration, and is 

correct, insert the missing circuit packs in this switch node carrier.

3. If administration does not match the physical configuration, and is 

incorrect, change the administration, and run this test again.

4. If none of the administered boards in this switch node carrier were 

inserted, fix any other SN-CONF errors by following the repair 
procedures for SN- CONF. Use display errors with category pnc 

to view SN-CONF errors. Use list sys-link to see if any INLs, 

LNLs, or RNLs are down. If any INLs, LNLs, or RNLs are down, see 

on page 2175 for fixing link problems.

PASS

If this test passes, every administered circuit pack in this switch node carrier 

was inserted.

 2 of 2