Avaya 03-300430 User Manual

This test is nondestructive.
This test queries an SNC for any existing failures and any unacknowledged “cleared failure” 
messages. Each failure generates an error and alarm entry against SNC-BD, SNC-LINK, or 
SNC-REF. A “cleared failure” message is a message an SNI circuit pack sends to software 
indicating the resolution of a previous failure. This message is “unacknowledged” if the SNI 
circuit pack never receives a response from software indicating it’s own receipt of the original 
“cleared failure” message.
If no failures are detected by the SNC circuit pack, this test will pass.
If this test reports failures, the test board screen shows FAIL with no FAIL code. Use 
display errors pnc to show the error log and view SNC-related errors: SNC-BD, 

SNC-LINK, and SNC-REF.

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2300

ABRT

The downlink message necessary to run this test could not be sent.

1. Retry the command at 1-minute intervals up to 3 times.

2301

ABRT

The software timer could not be set before sending the downlink message 
necessary to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

 1 of 3