Avaya 03-300430 User Manual

2304

ABRT

SNC circuit pack responded that it is not able to run the test requested by 
software.

1. Retry the command at 1-minute intervals up to 3 times.

2306

ABRT

The SNC circuit pack is not responding to test requests sent by software.

1. Run the test led switch-node for the switch node where the 

SNC resides to verify whether the LEDs on the board light.

2. If the LEDs on the other boards in the carrier light, but the LEDs on 

this board do not light, run test 760 using test board location l 

for the active SNC in this carrier. Wait 5 minutes and then try step 1 
one more time. If the LEDs on this board still do not light, replace this 
board. Replacing an SNC may be service interrupting. See 

on page 2000 for the procedure for 

replacing an SNC.

3. If none of the LEDs light for the boards in the same carrier as this 

board, fix any problems associated with the connectivity of this carrier 
to the server.

a. Use list fiber-link to list the fiber connections to this carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.

c. Enter display errors, and follow the repair procedures for any 

EXP-INTF error entries associated with the controlling IPSI 
connected PN.

d. Follow the repair procedures for any SYNC, SNI-BD, SNC-BD, 

FIBER-LK, or SNI-PEER error entries.

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

PASS

The “reset” message was sent out successfully to the active SNC or to an 

SNI. A PASS does not necessarily mean the SNC circuit pack was 

successfully reset. The reset can be verified by checking that the red and 

green LEDs turn on and then turn off. If an SNC circuit pack fails one of the 

firmware tests run during its reset sequence, the red LED will stay on and 

the circuit pack should be replaced.

 2 of 3