Avaya 03-300430 User Manual

122

FAIL

The SNI circuit pack cannot communicate with its neighbor via the circuit 
path.

1. Fix any on-board errors (SNI-BD, EXP-INTF, and/or DS1C-BD) 

against the components of this fiber link by using display errors 

and display alarms and following the repair procedures. (Use the 
list fiber-link command to find the fiber link associated with 

this SNI. The display fiber-link command can then be used to 

find the endpoints of the fiber link and the DS1C circuit pack locations 
if this fiber link has a DS1 Converter complex administered.)

2. Enter display errors and follow the repair procedures for any 

FIBER-LK entries for the fiber this SNI is administered on. Check 
list fiber-link to determine the administered fiber.

3. If this fiber link has a DS1 converter complex administered, enter 

display errors and display alarms and follow the repair 

procedures for any off-board DS1C-BD or DS1-FAC entries for either 
of the DS1C boards administered or for the DS1 facilities associated 
with either of the DS1C boards administered.

4. Replace this SNI.

PASS

The SNI passed the sni circuit path test.

0

NO 

BOARD

No board was detected by the test.

1. Check that board is properly translated and inserted.

2. Run the test again. If it fails, reset the board. An SNI should be reset 

instead of reseating the circuit pack. The reset board command 

should almost never be used on an SNI. It may be necessary to use 
reset board if the SNI circuit pack gets into a mode where it cannot 

communicate with software. If an SNI with active errors and alarms is 
reset, the errors and alarms may take a while to come back, therefore 
reset board can mask real problems.

3. Run the test again. If it fails, the ID chip on board may be bad. 

Replace the board and retest.

 11 of 11