Avaya 03-300430 User Manual

2304

ABRT

SNI circuit pack responded that it is not able to run the test requested by 
software.

1. Retry the command at 1-minute intervals up to 3 times.

2306

ABRT

The SNI circuit pack is not responding to test requests sent by software.

1. Run test led switch-node for the switch node where the SNI 

resides to verify whether the LEDs on the board light.

2. If the LEDs on the other boards in the carrier light, but the LEDs on 

this board do not light, run test 760 using test board location l 

for the active SNC in this carrier. Wait 5 minutes and then try step 1 
one more time. If the LEDs on this board still do not light, replace this 
board. Replacing an SNI may be service interrupting. See 

on page 2046 for the procedure for replacing an 

SNI.

3. If none of the LEDs light for the boards in the same carrier as this 

board, fix any problems associated with the connectivity of this carrier 
to the server.

a. Check list fiber-link to see the fiber connections to this 

carrier.

b. Check the LEDs on every SNI and EI, and fix any fiber problems.

c. Enter display errors, and follow the repair procedures for any 

EXP-INTF error entries associated with the controlling IPSI 
connected PN.

d. Follow the repair procedures for any SYNC, SNI-BD, SNC-BD, 

FIBER-LK, or SNI-PEER error entries.

4. Follow the procedure described above, SNI Manual Loopback to 

determine whether the circuit pack or the fiber connection is faulty.

127

FAIL

The data is not correctly looped around.

1. Check the lightwave transceiver or metallic physical connections.

2. If connections OK, replace the lightwave transceiver or the metallic 

interconnect.

3. If the test still fails, replace the SNI circuit pack.

PASS

No problems associated with this test are detected on the SNI.

 2 of 3