Avaya 03-300430 User Manual

Notes:

For every error in 

circuit pack reporting the error indicates that it has a problem with the control path, circuit path, 
or packet path to the SNI peer in the slot indicated on the error table.

1. Run the Failure Audit test (#777) to confirm if the error still exists.

2. If the SNI reports an SNI-PEER error against a slot that does not contain an SNI, either 

change circuit pack administration using change circuit-pack to un-administer the 

SNI, or insert an SNI into the indicated slot. Use list configuration carrier to 

determine if an SNI circuit pack is inserted. Otherwise, use display errors and look at 

every SNI-PEER error in the log. If either of the following two conditions are present, follow 

●

Do many SNIs have SNI-PEER errors pointing to the same 2 adjacent SNIs?

●

Do 2 adjacent SNIs have SNI-PEER errors pointing to many other SNIs?

3. If neither condition is present, follow 

 below. When using either procedure, see 

page 2000 for circuit pack replacement instructions.

Proceed through the following steps until the problem is resolved:

1. Perform the 

 procedure in Maintenance Procedures (03-300192).

2. Replace the SNI pointed to by the SNI-PEER Error Type (see the SNI Slot column in 

3. Replace the SNI reporting the SNI-PEER error.

4. Replace the active SNC.

2, 3

1, 257

4, 5

513, 769

6, 7

1025, 1281

8, 9

1537, 1793

13, 14

2049, 2305

15, 16

2561, 2817

17, 18

3073, 3329

19, 20

3585, 3841