Avaya 03-300430 User Manual

This test is nondestructive. The test reads and clears the circuit pack’s LAN Receive Parity 
Error Counter. This counter is incremented by the circuit pack when it detects a parity error in 
data received from the Packet bus. These errors may indicate problems with a circuit pack, 
Packet bus, or with another circuit pack on the bus. Use this test to verify the repair.

2000

ABRT

Response to the test was not received from the circuit pack within the 
allowable time period.

1. If the test aborts repeatedly up to 5 times, reset the circuit pack with 

busyout board location and reset board location.

2. If the test aborts again, replace the circuit pack.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

2012

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 5 times.

1–10

FAIL

The circuit pack is still detecting errors of this type. The Error Code 
indicates the value of the on-board error counter.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to fail, verify the validity of the Packet bus. Run the 

Packet bus maintenance test with test pkt P long. If any Packet 

bus test fails, see 

recommended repair procedures.

3. If the Packet bus test passes, check the validity of the circuit pack. 

Execute a test that involves data transmission onto the Packet bus. For 
example, test port location may use the connectivity tests of the 

BRI-PORT MO. If the test fails, refer to the repair procedures; 
otherwise, proceed to the next step.

4. Other circuit packs on the Packet bus may be the cause of the parity 

error for the failed test. Use display errors to check the Error Log 

for other alarmed circuit packs. Resolve any alarms for other circuit 
packs as well. Rerun the LAN Receive Parity Error Counter test (#595).

PASS

No errors detected.