Avaya 03-300430 User Manual
Communication Manager Maintenance-Object Repair Procedures
2206 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
s. Error Type 3588: the board receives D-channel data from the bus faster than it can process
the data. The FIFO RAM buffers overflowed. This error occurs occasionally due to the
statistical sizing of the buffers; however, frequent occurrences may indicate a LAPD
parameter mismatch between the two endpoints of a packet-switched connection. Run the
long test sequence, and pay particular attention to the results of the Receive FIFO Overflow
test (#625).
statistical sizing of the buffers; however, frequent occurrences may indicate a LAPD
parameter mismatch between the two endpoints of a packet-switched connection. Run the
long test sequence, and pay particular attention to the results of the Receive FIFO Overflow
test (#625).
t. Error Type (3589: the BRI Port Local LAN Loop Around test (#618) failed. Run the long test
sequence, and pay particular attention to the results of Test #618.
u. Error Type 3590: an activated BRI port receives a frame containing a DLCI over a D
channel for which it does not have a translation. This error normally indicates an off-board
problem related to a state mismatch between the far end and the switch. This error is
logged only.
problem related to a state mismatch between the far end and the switch. This error is
logged only.
v. Error Type 3591: the circuit pack received a frame containing a DLCI over the TDM
D-channel for which it does not have a translation. This error occurs only on a system that
switches the packet implementation of the D-channel over the TDM bus, and indicates an
off-board problem related to the state mismatch between the board and the packet
implementation of the TDM D-channel. This error is logged only.
switches the packet implementation of the D-channel over the TDM bus, and indicates an
off-board problem related to the state mismatch between the board and the packet
implementation of the TDM D-channel. This error is logged only.
w. Error Type 3592: 1the port is generating too many uplinks and is taken out of service for a
period of time.
x. Error Types 3841–3942:
contains the received ISDN cause values for Errors 3841–3942 that are recorded in the
hardware error logs. Unless otherwise stated, the cause values are D-channel events. The
Aux Data field shows which port caused the error.
hardware error logs. Unless otherwise stated, the cause values are D-channel events. The
Aux Data field shows which port caused the error.
Table 786: Aux Data Values for Error 3841–3942
Aux Data
Value
Value
Type of
Problem
Problem
Meaning
2
admin
No route to specific transit network
3
admin
No route to destination (or Germany bcap not imp)
6
admin
Channel unacceptable
18
switch
problems
No user responding
38
switch
problems
Network failure
50
subscription
Requested facility not subscribed
52
admin
Outgoing calls barred
54
admin
Incoming calls barred
1 of 2