Avaya 03-300430 User Manual

This test is nondestructive.
This test is used to check the application layer communications across the in-service ISDN D 
channel. The test passes if a status inquiry message is successfully sent, fails if the signaling 
link is down, and aborts if a query is already running or there is an internal error.

1005

ABRT

The test aborted due to a configuration problem. This test may not be 

applicable, or it may be disruptive to terminal equipment other than a voice 

terminal (for example, a modem pool member or Music on Hold). This error 

can be ignored.

1019

ABRT

Test is already running.

1113

ABRT

The signaling link is down.

1. Use test port location long to clear any errors which prevent 

establishment of the signaling link.

2. Examine the results of Test #626, which is executed with the 

command. If this test aborts or fails, follow the repair procedure for the 
Signaling Link Status test.

3. Escalate problem if BRI Layer 3 Query test continues to abort.

1187

ABRT

The circuit pack or port may have been busied out by a technician.

1. Look in the Error Log for Error Type 18 (busied out) for TBRI-BD or 

TBRI-PT.
a. If this Error Type is present for TBRI-PT, then release the port with 

release port location and run the test again.

b. If the error is present for both TBRI-BD and TBRI-PT, then release 

the circuit pack with release board location and run the test 

again.

When you release the circuit pack, you release every port associated with it. 

If certain ports still need to be busied out, use busyout port location 

to busy them out.

2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.

2012

ABRT

Internal system error

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

PASS

The switch has successfully sent a Status Enquiry message.