Avaya 03-300430 User Manual

1005

ABRT

The test aborted due to a configuration problem. This test may not be 

applicable, or it may be disruptive to terminal equipment other than a voice 

terminal (for example, a modem pool member or Music on Hold). This error 

can be ignored.

1018

ABRT

The test is disabled.

1. Enable maintenance by entering y in the Maintenance Tests field on 

page 2 of the change trunk-group screen.

1113

ABRT

The signaling link has failed, so the system cannot send any messages on 
behalf of this trunk.

1. Check the results of Test #1251 (Signaling Link State test).

1114

ABRT

The signaling link is in a transitional state.

1. Retry the command at 1-minute intervals up to 5 times.

1116

ABRT

The trunk is not in a service state which is appropriate for running the test. 

This test is only performed in the OOS/FE state.

1117

ABRT

A service state audit message is outstanding.

1. Wait two minutes and then try again.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

FAIL

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to fail, escalate the problem.

PASS

Wait 4 minutes and then check the Error Log for any new errors of type 

3073. If there are none, then both sides of the ISDN connection agree on the 

service state; the negotiation succeeded. If there is a new 3073 error, then 

the negotiation failed (the far-end switch twice failed to respond within 2 

minutes). The switch automatically retries every 15 minutes. If the trunk was 

initially in-service, it is now placed in the maintenance/far-end state. 

Incoming calls are accepted, but no outgoing calls can be originated. If an 

incoming call is presented, another Service State Audit is immediately 

performed in an attempt to put the TN2185 Trunk-Side ISDN-BRI channel in 

the proper state.

 2 of 2