Avaya 03-300430 User Manual

Note:

 / 

: This test aborts with Error Code 1412 on the G700.

One or more Network Processing Elements (NPEs) reside on each circuit pack with a TDM-bus 
interface. (The TN464 UDS1 circuit pack has one SCOTCH-NPE chip instead of several NPE 
chips). The NPE controls port connectivity and gain, and provides conferencing functions on a 
per-port basis. The Conference Circuit test verifies that the NPE channel for the port being 
tested can correctly perform the conferencing function. The NPE is instructed to listen to several 
different tones and conference the tones together. The resulting signal is then measured by a 
Tone Detector port. If the level of the tone is within a certain range, the test passes.

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test were not available. The 
port may be busy with a valid call.

1. Use display port location to determine the trunk group/

member number of the port. Use status trunk to determine 

the service state of the port. If the service state indicates that 
the port is in use, then the port is unavailable for certain tests. 
Wait until the port is idle before retesting.

2. If the port status is active but the port is idle (no calls), check 

the error log for Error Type 1025 (see the error log table for a 
description of this error and required actions). The port may be 
locked up.

3. If the port status is idle, retry the command at 1-minute intervals 

up to 5 times.

1002

ABRT

The system could not allocate time slots for the test. The system 
may be under heavy traffic conditions, or it may have time slots out 
of service due to TDM-BUS errors. Use status health to 

determine if the system is experiencing heavy traffic.

1. If the system has no TDM-BUS errors and is not handling 

heavy traffic and the port status is idle, retry the command at 
1-minute intervals up to 5 times.

 1 of 5