Avaya 03-300430 User Manual

1000

ABRT

System resources required to run this test were not available. The port 
may be busy with a valid call.

1. Use display port location to determine the trunk group/

member number of the port. Use status trunk to determine the 

service state of the port. If the port is in use, wait until the port is idle 
before testing.

2. If the port status is active but the port is idle (no calls), check the error 

log for Error Type 1025 (see the error log table for a description of this 
error and required actions). The port may be locked up.

3. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

1004

ABRT

Far end is seizing the trunk while the test is ongoing. A glare situation is 
detected. Current test is designed to be aborted.

1. Use display port location to determine the trunk group/

member number of the port. Use status trunk to determine the 

service state of the port. If the port is in use, wait until the port is idle 
before testing.

2. If the port status is idle, retry the command at 1-minute intervals up to 

5 times.

1005

ABRT

Test failed due to incompatible configuration administered on Trunk Group 
form.

1. Verify the following fields on the Trunk Group administration form:

a. Is trunk direction incoming only?

b. Is trunk outgoing type either automatic or immediate-start?

c. Is trunk the 24

th

 port of the DS1 Interface circuit pack or media 

module while common control channel signaling is specified?

2. If the trunk has been administered using the above information, this 

test should abort.

1018

ABRT

The test was disabled by translation. You might want to determine why the 
test has been disabled before you enable it.

1. Verify that the Maintenance Test field on the Trunk Group 

administration form is n. To enable the test, change the trunk 
administration and enter y in the Maintenance Test field.

2. Repeat the test.

 2 of 5