Avaya 03-300430 User Manual

b. Error Type 1: digit time-out. This occurs when the far-end PBX began transmitting digits too 

late (10 seconds) after receiving the signal indicating ready to receive digits (if any). This 
can occur on an incoming immediate, wink, or delay dial line. Check the far-end PBX to 
ensure a translation match at both ends. This error does not apply to TN497.

c. Error Type 1: rotary dial before wink. This occurs when the far-end PBX starts dialing 

before the PBX sends the wink on a wink-start or delay-dial trunk. Check the far-end PBX to 
ensure a translation match at both ends. This error does not apply to TN497.

d. Error Type 1: rotary dial too early. This occurs when the far-end PBX starts dialing too soon 

(about 50ms) after seizure on a wink start or delay dial line. Check the far-end PBX to 
ensure a translation match at both ends. This error does not apply to TN497.

e. Error Type 1: on hook before wink. This occurs when the far end goes on hook before a 

wink. Check the far-end PBX to ensure a translation match at both ends. This error applies 
only to TN439.

f. Error Type 1: on an outgoing wink-start or delay-dial trunk, the wink time was too short 

(less than 80ms) for a valid signal. Check the far-end PBX to ensure a translation match at 
both ends. This error does not apply to TN497.

g. Error Type 15: this is a software audit error that does not indicate any hardware 

malfunction. Run the short test sequence, and investigate associated errors (if any).

h. Error Type 18: this indicates that the trunk in question has been busied-out by maintenance 

personnel.

i. Error Type 130: the circuit pack has been removed or has been insane for more than 

11 minutes. To clear the error, reinsert or replace the circuit pack. TN439 does not alarm this 
error. This error does not apply to TN497.

j. Error Type 257: the rotary dial rate was too slow — less than 8 pulses per second. Check 

the far-end PBX to ensure a translation match at both ends.

k. Error Type 257: the rotary dial rate was too fast — above 12 pulses per second. Check the 

far-end PBX to ensure a translation match at both ends.

l. Error Type 257: the time between digits was too short (less than 300ms). Check the far-end 

PBX to ensure a translation match at both ends.

m. Error Types 513, 769, 1281: these errors do not apply to TN439 and TN497.

n. Error Type 1025: this indicates that the trunk is still seized with an incoming call. The 

far-end PBX is not releasing the trunk after the call was dropped. Check the far-end PBX for 
problems.

Once the trunk is released from the call, the severity of this problem is decreased. If Error 
Type 1025 does not appear again, this means that the problem has been corrected. Verify 
that Error Type 1025 does not reappear in the Error Log.