Avaya 03-300430 User Manual

1002

ABRT

The system could not allocate time slots for the test. The system may be 
under heavy traffic conditions or it may have time slots out-of-service due 
to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

repeat test at 1-minute intervals up to 5 times. 

1003

ABRT

The system could not allocate a tone receiver for the test. The system may 
be oversized force.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals up 

to 5 times.

1004

ABRT

The port was seized by a valid call during the test. The test has been 

aborted. Use display trunk-group xx to determine the trunk group/

member number of the port. Use status trunk to determine the service 

state of the port. If the service state indicates that the port is in use, then the 

port is unavailable for certain tests. Wait until the port is idle before 

retesting.

1018

ABRT

The test has been disabled by administration.

1. Verify that the Maintenance Test field on the Trunk Group screen is n. 

To enable the test, use change trunk-group x where x is the 

number of the trunk group to be tested, and enter y in the 
Maintenance Test field.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test. This 
could be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 4