Avaya 03-300430 User Manual

1005

ABRT

This test is not valid for this trunk translation. Must be a wink-start or 
delay dial trunk and must be outgoing or 2-way for this test to run. 
For the TN2140, the trunk must also be continuous-seize-ack or 
discontinuous-seize-ack.

1. Check trunk translation. If it is not a wink-start or delay dial 

trunk, this abort message should be ignored.

1018

ABRT

Test disabled via administration.

1. Verify that the Maintenance Tests field on the Trunk Group 

screen is n. To enable the test, enter change trunk-group x 

where x is the number of the trunk group to be tested, and enter 

y in the Maintenance Tests field.

1040

ABRT

This test is not performed for trunk ports administered as access 
endpoints.

1. Verify this port is an access endpoint by using display port.
2. If the port has been administered as an access endpoint, then 

this test should abort.

2000

ABRT

Seizure message is not received back within 10 seconds.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2. If the test continues to fail, check the far-end PBX to ensure a 

translation match at both ends.

3. Check the facility.

2100

ABRT

Could not allocate the necessary system resources to run the test. 
This could be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

3

FAIL

No dial tone detected from the other end. (TN439 circuit packs only.)

1. Retry the command at one minute intervals up to five times.

2. If the test continues to fail, check the far-end PBX to ensure a 

translation match at both ends.

3. Check the facility.

 2 of 3