Avaya 03-300430 User Manual

None

ABRT

The system was not able to allocate all the resources needed for this 
test or there was an Internal system error.

1. Retry the command at 1-minute intervals up to 5 times.

1

ABRT

The system could not allocate all the resources needed to test the 
DTMF tones.

1. Retry the command at 1-minute intervals up to 5 times.

1001

ABRT

The system was not able to put the tone generation facility in the 
appropriate mode to test it.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test connection. This 
can happen when the system is heavily loaded. If the system is not 
heavily loaded, use test tdm port-network P to test the TDM 

bus.

1. Retry the command at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test connection. 
This can happen when the system is heavily loaded or there is not an 
IPSI or Tone Detector circuit pack in the port network where this test is 
being executed.

1. Make sure there is an IPSI or Tone Detector circuit pack in the 

same port network.

2. If the circuit pack is missing, install one in the same port network.

3. Allow approximately 1-minute for Tone Detector maintenance to 

run on the newly inserted IPSI or Tone Detector circuit pack.

4. Retry the command at 1-minute intervals up to 5 times.

1022

ABRT

Tone detection for the system is administered as wide broadband (tone 

detection mode 5), and the Tone Detector used for this test was not a 

TN420C (the only circuit pack with this capability). GPTD ports on other 

types of Tone Detector circuit packs are taken out of service since they 

cannot provide the administered function. Either:

●

Change the tone-detection mode administered on the 
system-parameters country-options screen.

●

Remove all non-TN420C circuit packs from the system.

 1 of 2