Avaya 03-300430 User Manual

This test can be invoked by system technician personnel for any ADM TSC administered in the 
switch. Most of the error conditions on the following table will not log an error, but switched 
services may take some type of recovery action in certain instances.
This test sends a USER INFORMATION TSC heartbeat message inquiry across an ADM TSC 
to determine whether the far end can respond to a USER INFORMATION TSC heartbeat 
message.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Execute the test tsc-administered command at 1-minute 

intervals up to 5 times.

1005

ABRT

The Administered TSC does not exist.

1. Display the administration for the Administered TSC.

2. If an Administered TSC exists, execute the test 

tsc-administered.

1113

ABRT

The D channel is out-of-service.

1. See 

1145

ABRT

There is congestion in the network.

1. Enter the status tsc-administered command at 1-minute 

intervals up to 5 times.

2. If the congestion does not clear, disable and enable the Administered 

TSC using change signaling-group grp#.
NOTE: To disable the Administered TSC, display the (administration) 
Signaling Group screen using change signaling-group grp#, 

where group is the number of the signaling group under which the 

suspect TSC is administered. Set the Enable field to n. To enable the 
ADM TSC, set the Enable field to y.

3. If the congestion still does not clear, check other nodes in the network.

 1 of 4