Avaya 03-300430 User Manual

1303

FAIL

The UDS1 circuit pack Suffix is incorrect for CSU module/T1 sync splitter 

or E1 Sync Splitter administration.
The UDS1 circuit pack Suffix is incorrect for CSU module/T1 sync splitter 
administration. The Near-End CSU Type field on the add ds1 screen 

has been administered as integrated but the UDS1 circuit pack is not a 
TN464F or higher suffix UDS1 board.

1. If the CSU module/T1 sync splitter is to be used, and the Near-End 

CSU Type field is set to integrated to allow for CSU module/T1 sync 

splitter administration, remove the circuit pack and replace it with a 
TN464F or higher suffix board. Otherwise, use change ds1 to set 

the Near-End CSU Type field to other.

The UDS1 circuit pack Suffix is incorrect for E1 Sync Splitter 
administration. The E1 Sync-Splitter? field on the add ds1 screen has 

been administered as y but the UDS1 circuit pack is not a TN464F or 
higher suffix UDS1 board.

1. If the E1 Sync Splitter is to be used, and the E1 Sync-Splitter field is 

set to y to allow for E1SS administration, remove the circuit pack and 
replace it with a TN464F or higher suffix board. Otherwise, use 
change ds1 to set the E1 Sync-Splitter field to n.

1310

FAIL

The UDS1 Board Loopback (BLB) demand test (#1209) failed.

1. Repeat the test using test ds1-loop location ds1/

2. If the BLB test continues to fail, then replace the UDS1-BD circuit 

pack.

3. Run this test again.

 5 of 9