Avaya 03-300430 User Manual

 

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

2000

ABRT

Response to the test was not received within the allowable time period. 
This may be due to hyperactivity. Error Type 1538 in the error log 
indicates hyperactivity. The hyperactive circuit pack is out of service, and 
one or more of the following symptoms may be exhibited.

1. The UDS1-BD tests (such as Tests #138 and #139) are aborting with 

Error Code 2000.

2. The tests run on the ports of this circuit pack are returning a no-board 

result.

3. A busyout or a release command has no effect on the test results.
4. A list config shows that the circuit pack and its ports are properly 

installed.

When hyperactivity occurs, the circuit pack is isolated from the system, 

and all of its trunks are placed into the out-of-service state. The system will 

try to restore the circuit pack within 15 minutes. When no faults are 

detected for 15 minutes, the UDS1 interface circuit pack is restored to 

normal operation. Every UDS1 Interface trunk is then returned to the 

in-service state. Hyperactivity is often caused by the associated facility. In 

such a case, faults (such as slips, misframes, or blue alarms) would be 

entered in the error log. In addition, many hardware errors would be 

logged against the associated trunk circuits. If the facility is OK and the 

error occurs again after 15 minutes, replace the circuit pack.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 3