Avaya 03-300430 User Manual

1

ABRT

During testing of the primary information channel, system resources may 
not have been available. Also, the port may have been busy during the test.

1. Check the port status.

2. Use display port location to determine the voice port extension 

of the port. Use status station to determine the service state of the 

port. If the port is active, it is unavailable for this test. Wait until the port 
is idle.

3. Retry the command at 1-minute intervals up to 5 times.

2

ABRT

System resources may not have been available, or the port may have been 
busy during the test.

1. Verify that the port’s status is idle.

2. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be active.

1. Use display port location to determine the voice port extension 

of the port. Use status station to determine the service state of the 

port. If the port is active, it is unavailable for certain tests. Refer to 
“Status” commands in 

 in Maintenance 

Commands Reference (03-300191), for a full description of every 
possible state. Wait until the port is idle before testing.

2. If the port’s status is idle, retry the command at 1-minute intervals up to 

5 times.

1001

ABRT

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1002

ABRT

The system could not allocate time slots for the test. The system may be 
under heavy traffic conditions, or it may have time slots out-of-service due 
to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

retry the command at 1-minute intervals up to 5 times.

 1 of 2