Avaya 03-300430 User Manual

This test verifies that this port’s NPE channel talks on the selected time slot and never crosses 
over to time slots reserved for other connections. If the NPE is not working correctly, one-way 
and noisy connections may be observed. This test is part of the long test sequence and 
executes in about 25 seconds.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

port is active, it is unavailable for certain tests. Wait until the port is idle 
before testing.

2. Retry the command at 1-minute intervals up to 5 times.

1001

ABRT

Could not allocate the necessary system resources to run this test.

1002

ABRT

The system could not allocate time slots for the test. The system may be 
under heavy traffic conditions or it may have time slots out-of-service due to 
TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic, 

then retry the command at 1-minute intervals up to 5 times.

1003

ABRT

The system could not allocate a tone receiver for the test. The system may 
be oversized for the number of Tone Detectors present, or some Tone 
Detectors may be out of service.

1. Resolve any TTR-LEV errors.

2. Resolve any TONE-PT errors.

3. Retry the command at 1-minute intervals up to 5 times.

 1 of 2