Avaya 03-300430 User Manual

1000

ABRT

The test was aborted because system resources required to run this test 
were not available. The port may be busy with a valid call. Use display 
port PCSSpp to determine the station extension of the port. Use status 
station to determine the service state of the port. If the service state 

indicates that the port is in use, then the port is unavailable for certain 
tests. You must wait until the port is idle before retesting.

1. If the port is idle, retry the command at 1-minute intervals a maximum 

of 5 times.

1004

ABRT

The port received an EXT-DEV failure during the test. The test has been 
aborted.

1. Before retesting, enter test external-device-alarm port 

location to determine whether the port is reporting an EXT-DEV 

failure.

2. If the port has no EXT-DEV failures, retry the command at 1-minute 

intervals up to 5 times.

1006

ABRT

This port has been busied out by command.

1. Check Error Log for Error Type 18 (port busied out). If present, use 

release port location to release the port and run the test again.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1

FAIL

This failure does not indicate a hardware problem. The switchhook audit 
failed. This condition may occur when the audit is performed at the same 
time that the terminal equipment goes off-hook.

1. Before retesting, enter test external-device-alarm port 

location to determine whether the port is reporting an EXT-DEV 

failure. Wait until the port has no EXT-DEV failures.

2. If the port has no EXT-DEV failures, retry the command at 1-minute 

intervals up to 5 times.

7

FAIL

The translation update failed. This does not indicate a hardware problem 

but may be an internal software error.

 2 of 3