Avaya 03-300430 User Manual

This test updates the analog port’s message lamp state (if it has one) and translations with 
information in the software.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1004

ABRT

The port was seized by a valid call during the test.  The test has been 
aborted.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If the 

port is active, wait until it is idle.

2. Retry the command at 1-minute intervals up to 5 times.

3. If the test continues to abort and the port is not in use, escalate the 

problem.

1005

ABRT

The test was aborted due to a configuration problem.  This test may not be 

applicable, or it may be disruptive to terminal equipment other than a voice 

terminal (for example, the modem pool member or Music On Hold).

1006

ABRT

This port has been busied out by command, or taken out-of-service by the 
failure of the NPE Crosstalk test.

1. Look in the error log for error type 18 (port busied out) for this port. If 

this error is present, release the port with release station 
extension, and run the test again.

2. Check the error log for error type 1025 (NPE crosstalk test failed) for 

this port. If this error is present, investigate the errors associated with 
the NPE Crosstalk test (#6).

3. Make sure that the terminal is connected and in service, and then 

retest.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2