Avaya 03-300430 User Manual

1

FAIL

This does not indicate a hardware problem.  The switchhook audit failed.  
The other updates were not performed because of this failure.  This may 
occur when the audit is performed at the same time the terminal equipment 
goes off-hook.

1. Use status station to determine when the port is available.
2. Retry the command at 1-minute intervals up to 5 times.

5

FAIL

This may be an internal software error.  The message waiting lamp update 

failed.  The translation and ringer updates were not performed because of 

this failure.

7

FAIL

The translation update failed.  There may be an internal software error.  The 

ringer update was not performed because of this failure.

8

FAIL

This does not indicate a hardware problem.  There may be an internal 
software error.  The ringer update failed.

1. Retry the command at 1-minute intervals up to 5 times.

PASS

The software and the port processor have the same status.  User-reported 

troubles on this port should be investigated by using other port tests, by 

examining station wiring, or by examining the station.

0

NO 

BOARD

The test could not relate the internal ID to the port (no board).  This could be 
due to incorrect translations, no board is inserted, an incorrect board is 
inserted, or an insane board is inserted.

1. Verify that the board’s translations are correct.  Enter list config 

and resolve problems.

2. If the board was found to be correctly inserted in step 1, enter busyout 

3. Enter reset board location
4. Enter release board location
5. Enter test board location long

This should re-establish the linkage between the internal ID and the port.  If 

not, verify that a valid board is inserted.

 2 of 2