Avaya 03-300430 User Manual
ANL-LINE (8-Port Analog Line)
Issue 1 June 2005
411
Battery Feed Test (or Port Diagnostic Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling, rotary dial pulsing,
transmission, and balance. This test checks the signaling and switchhook capabilities of the
battery feed chip by terminating the port, applying battery, and trying to detect a current.
transmission, and balance. This test checks the signaling and switchhook capabilities of the
battery feed chip by terminating the port, applying battery, and trying to detect a current.
Table 121: Test #35 Battery Feed Test Results
Error
Code
Code
Test
Result
Result
Description / Recommendation
ABRT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000
ABRT
System resources required to run this test are not available. The port may
be busy with a valid call. This result is also reported for the system’s
Music-on-Hold port when it is off-hook, which it usually is.
be busy with a valid call. This result is also reported for the system’s
Music-on-Hold port when it is off-hook, which it usually is.
1. Enter display port location to determine the station’s extension.
Enter status station extension to determine the service state of
in the Maintenance
Commands Reference (03-300191), for a full description of every
possible state. If the port is active, it will be unavailable for certain
tests. Wait until the port is idle before retesting.
possible state. If the port is active, it will be unavailable for certain
tests. Wait until the port is idle before retesting.
2. When the port is idle, retry the command at 1-minute intervals up to 5
times.
1004
ABRT
System resources required to run this test are not available. The port may
be busy with a valid call.
be busy with a valid call.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If the
service state indicates that the port is active, then the port is
unavailable for certain tests. Refer to
unavailable for certain tests. Refer to
in
the Maintenance Commands Reference (03-300191), for a full
description of every possible state. Wait until the port is idle before
retesting.
description of every possible state. Wait until the port is idle before
retesting.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort and the port is idle, escalate the problem.
1 of 3