Avaya 03-300430 User Manual

1005

ABRT

The test was aborted due to a configuration problem.  This error code 
occurs under either of the following conditions:

1. This test may not be applicable, or it may be disruptive to terminal 

equipment other than a voice terminal (for example, the modem pool 
member or music on hold).

2. The circuit pack is one of the following:

- TN742 vintages 13,14, and 15

- TN769 vintages 3, 4, and 5

1018

ABRT

Test disabled via administration. The default for the Test field on the is y. 
Determine why this field was set to n on this station. It may be due to the 
ringing application Test E48, which can be customer or terminal disturbing.

1. To enable the test for a particular station, enter change station 

extension and set the Test field to y.

1392

ABRT

This port is currently a TTI port and the test will not execute on it.

1. Verify that the port is a TTI port using either the display port 

command (the display shows that the port is a TTI port) or list 
config (the display shows a t for the port).

2. If either list config or display port indicate that the port is not 

a TTI port, escalate the problem.  If both commands indicate that the 
port is a TTI port, the abort is correct for the test, and no action is 
necessary.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

System resources required to run this test are not available.  Either a 
system allocation to get information about the port or to put the port into a 
service state failed or the attempt to put the port in connection with a tone 
source failed (this could be a Tone-Clock problem).  The Tone-Clock and 
Tone Detectors could be having a communication problem.  For example, 
the companding modes could be out of synchronization.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 3