Avaya 03-300430 User Manual

FAIL

The port’s battery feed chip is unable to supply sufficient power to the 
terminal equipment.  This may occur when the test is performed at the 
same time that the terminal equipment goes off-hook.

1. Use status station to determine when the port is available for 

testing.  When the port becomes available for testing, retry the 
command at 1-minute intervals a minimum of five times.

2. If the test continues to fail, determine whether the customer is 

experiencing problems on this line.  Replace the circuit pack only if the 
customer is experiencing problems.

PASS

The port’s battery feed chip is able to provide power to the station 

equipment to detect on-/off-hook.  However, the battery feed chip may still 

be unable to provide power for touch-tones.  If tones are heard when 

buttons are pressed, then the battery feed chip is functioning correctly; 

otherwise, replace the circuit pack because this port is defective.  

User-reported troubles on this port should be investigated by using other 

port tests, by examining station wiring, by examining the station, and by 

ensuring that the terminal is correctly translated as off-premises or 

on-premises.

Note:

This test always passes for circuit packs TN712 prior to 
Vintage 14 and TN742 prior to Vintage 6.

0

NO 

BOARD

The test could not relate the internal ID to the port (no board).  This could 
be due to incorrect translations, no board is inserted, an incorrect board is 
inserted, or an insane board is inserted.

1. Verify that the board’s translations are correct.  Enter list config, 

and resolve any problems that are found.

2. If the board was found to be correctly inserted in step 1, enter 

3. Enter reset board location
4. Enter release board location
5. Enter test board location long

This should re-establish the linkage between the internal ID and the port.  If 

not, dispatch to verify that a valid board is inserted.

 3 of 3