Avaya 03-300430 User Manual

This test updates the analog port’s message lamp state (if it has one) and translations (such as 
station type, dial type, network connection) with information kept in the software.  The software 
is updated with the switchhook state reported by the port processor.  When the ringer is in the 
off state, this test also turns off the station’s ringer to prevent constant ringing caused by 
defective hardware.

ABRT

Could not allocate the necessary system resources to run this test.

1004

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. Use display port location to determine the station extension. 

Use status station to determine the service state of the port. If 

the service state indicates that the port is active, then the port is 
unavailable for certain tests. Wait until the port is idle before retesting.

2. Retry the command at 1-minute intervals up to 5 times.

3. If the test continues to abort and the port is idle, escalate the problem.

1005

ABRT

The test was aborted due to a configuration problem.  This error code 
occurs under either of the following conditions:

1. This test may not be applicable, or it may be disruptive to terminal 

equipment other than a voice terminal (for example, the modem pool 
member or music on hold).

2. The circuit pack is one of the following:

- TN742 vintages 13,14, and 15

- TN769 vintages 3, 4, and 5

 1 of 3