Avaya 03-300430 User Manual

1004

ABRT

A valid call seized the port during the test and aborted the test.

1. Use display port location to determine the station extension.
2. Use status station extension to determine the service state of 

the port.

3. If the port is active, wait until it is idle before testing.  Retry the 

command at 1-minute intervals up to 5 times.

4. If the test continues to abort, escalate the problem.

1005

ABRT

This test was aborted due to a configuration problem.  The test is not 

applicable for this type of analog port.  This error can be ignored.

1006

ABRT

The port is out-of-service. The busy station extension has been 

given to this port. If the port is on a circuit pack, it may have been taken 
out-of-service by the failure of the NPE Crosstalk test.

1. Look for error type 18 (port busied out) for this port.  If this error is 

present, release the port with release station extension, and 

run the test again.

2. If the port is on a circuit pack, check for error type 1537 (NPE 

Crosstalk test failed) for this port.  If this error is present, investigate 
the errors associated with the NPE Crosstalk test (#6).

3. Make sure that the terminal is connected and in service, and then 

retest.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

2. If the test continues to abort, escalate the problem.

 2 of 3