Avaya 03-300430 User Manual

Notes:

a. The Announcement circuit pack can exhibit a condition that does not allow recording.

If the circuit pack gets locked into this state (this is an extremely rare condition), two of the 
Announcement Ports on the circuit pack will be unusable by software, one of which is the 
record port. Also, save/restore announcements will not work since the record port 

looks busy to the circuit pack. Note that software does not have any way of knowing this, 
and attempts to use the ports.

If the circuit pack is locked into this state, the following symptoms are observed:

2007

ABRT

The Announcement circuit pack thinks that Port 1 or Port 9 is busy. 

1. Retry the command at 1-minute intervals a maximum of 5 times.

2. If the test continues to abort, follow the Announcement Port 

maintenance procedures for Ports 1 and 9.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals a maximum of 5 times.

ABRT

Internal system error.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1-3

FAIL

Test failed. The error code indicates at which speech compression rate the 
test actually failed (one being the first rate tested, three being the last).

1. Reset the circuit pack via reset board PCSS and then run this test 

again. If the test still fails, replace the circuit pack (see Warning) and run 
this test again.

2. If there are recurring alarms on this circuit pack caused by this test 

failing, replace the circuit pack even if Step 1 works (see Warning).

!

WARNING:

Replacing the circuit pack results in loss of integrated 
announcements. See 

PASS

The record channel on the Announcement circuit pack is functioning properly. 

User-reported troubles on this circuit pack should be investigated using other 

circuit pack and port tests. Refer to 

page 465 for a description of the port tests.

 3 of 3