Avaya 03-300430 User Manual

This test is supported to determine the state of the clock generation circuitry on the 
Announcement circuit pack. This circuitry is used for controlling various pieces of the hardware, 
like the 140AY device. It is also used to synchronize the Announcement circuit pack with the 
clock that is on the backplane.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

ABRT

Internal system error.

1. Retry the command at 1-minute intervals a maximum of 5 times.

FAIL

Test failed. Announcement playbacks should sound corrupted.

1. Reset the circuit pack via reset board PCSS and then run this test 

again. If the test continues to fail, replace the circuit pack (see Warning).

2. If there are recurring alarms on this circuit pack caused by this test 

failing, replace the circuit pack even if Step 1 works (see Warning).

!

WARNING:

Replacing the circuit pack results in loss of integrated 
announcements. See 

on page 465 near the 

beginning of this Maintenance procedure.

PASS

The SP can properly process record/playback requests. User-reported 

troubles on this circuit pack should be investigated using other circuit pack 

and port tests. Refer to 

on page 465 for a 

description of the port tests.

 2 of 2

2000

ABRT

Response to the test request was not received within the allowable time 

period. If Error Type 1538 is present in the Error Log, follow the maintenance 

strategy recommended for this Error Type.

 1 of 2