Avaya 03-300430 User Manual

Notes:
The Announcement circuit pack can exhibit a condition that does not allow recording.
If the circuit pack gets locked into this state (this is an extremely rare condition), two of the 
Announcement Ports on the circuit pack (one of which is the record port) will be unusable by 
software. Also, save/restore announcements will not work, since the record port looks 

busy to the circuit pack. Note that software does not have any way of knowing this and attempts 
to use the ports.

1 

to

254

FAIL

Test failed. The error code indicates the number of byte count errors found 
by the Tone Detector.

1. Reset the circuit pack via reset board PCSS and then run this test 

again. If the test continues to fail, replace the circuit pack (see Warning).

2. If there are recurring alarms on this port caused by this test failing, 

replace the circuit pack even if Step 1 works (see Warning).

!

WARNING:

Replacing the circuit pack results in loss of integrated 
announcements. Refer to 

255

FAIL

Test failed. The Announcement Port and the Tone Detector never 
synchronized. Check for active GPTD-PT errors, and refer to 

on page 1308 to diagnose them first.

1. If there are no active GPTD-PT errors, reset the circuit pack via reset 

board PCSS and then run this test again. If the test continues to fail, 

replace the circuit pack (see Warning).

2. If there are recurring alarms on this port caused by this test failing, 

replace the circuit pack even if Step 1 works (see Warning).

!

WARNING:

Replacing the circuit pack results in loss of integrated 
announcements. Refer to 

PASS

This port can cleanly play announcements. User-reported troubles on this 

pack should be investigated using other port and circuit pack tests. Refer to 

on page 447 for a description of the 

circuit pack tests.

 3 of 3